Message Alert Tone; Message Recording Time - AT&T CL82351 User Manual

Answering system
Answering system settings

Message alert tone

When the message alert tone is set to On, and there is at least one new
message, the telephone base beeps every 10 seconds.
the message alert tone is set to off.
There is no audible alert at the handset.
To change the setting:
1. When the handset is in idle mode, press MENU/
2. Press q or p
CID
press /SELECT.
MENU
3. Press q or p
CID
press /SELECT.
MENU
4. Press q or p
CID
press /SELECT.
MENU
5. Press q or p
CID
6. Press /SELECT to save the setting. You hear a
MENU
confirmation tone. Press
NOTES:
• The message alert tone beeps only if all the conditions below are met:
- Answering system is on.
- Message alert tone setting is on.
- There are new messages.
• To temporarily turn off the message alert tone, see page 51.

Message recording time

You can set the recording time allowed for incoming
messages. The message length is 3 minutes by default.
To change the setting:
1. When the handset is in idle mode, press MENU/
enter the main menu.
2. Press q or p
CID
press /SELECT.
MENU
3. Press q or p
CID
press /SELECT.
MENU
4. Press q or p
CID
5. Press q or p
CID
/SELECT to save the setting. You hear a confirmation tone. Press
press
MENU
/CANCEL to cancel.
OFF
to scroll to >Answering sys, then
DIR
to scroll to >Ans sys setup, then
DIR
to scroll to >Msg alert tone, then
DIR
to choose >On or >Off.
DIR
/CANCEL to cancel.
OFF
to scroll to >Answering sys, then
DIR
to scroll to >Ans sys setup, then
DIR
to scroll to >Recording time, then press
DIR
to choose >3 minutes, >2 minutes, or >1 minute, then
DIR
SELECT
SELECT
48
Unless you change it,
to enter the main menu.
Remote code
Msg alert tone
>
MSG ALERT TONE
>On
Msg alert tone
>Recording time
to
RECORDING TIME
>3 minutes
/SELECT.
MENU
p
q
p
q
p
q
p
q