NETGEAR DGND3700 User Manual page 41

N600 Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700
You can use the WPS (Push 'N' Connect) or router interface method to add wireless devices
and other equipment to your wireless network.
WPS (Push N Connect) Method
' '

If your wireless device supports WPS (Push 'N' Connect), follow these steps:
1. Press the WPS button on the router front panel
2. Within 2 minutes, press the WPS button on your wireless device, or follow the WPS
instructions that came with the device. The device is now connected to your router.
3. Repeat steps 1–2 to add other WPS wireless devices.
Router Interface Method

To add clients (devices) using the router interface:
1. Select Add WPS Client at the top of the router menus. If you cannot select Add WPS
Client, select Setup > Wireless Settings and make sure that WPS is selected.
2. Click Next. The following screen lets you select the method for adding the WPS client.
Figure 14. Add WPS Client with push button method
3. Select either Push Button or PIN Number. With either method, the client wireless device
attempts to detect the WPS signal from the wireless modem router and establish a
wireless connection in the time allotted.
The PIN method displays this screen so you can enter the client security PIN number:
Figure 15. Add WPS Client with PIN number method
• While the wireless modem router attempts to connect to a WPS-capable device, the
WPS LED on the front of the wireless modem router blinks green. When the wireless
modem router establishes a WPS connection, the LED is solid green.
• If a connection is established, the wireless modem router WPS screen displays a
confirmation message.
4. Repeat to add another WPS client to your network.
.
Wireless Settings
41