Set Up Client-To-Gateway Vpn (Telecommuter Example) - NETGEAR DGND3700 User Manual

N600 Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700
Verify that the firmware is up to date, and make sure you have all the addresses and
parameters to be set on both sides. Assure that there are no firewall restrictions
Table 27. Configuration summary (telecommuter example)
VPN Consortium Scenario
Type of VPN:
Security scheme:
IP addressing:
Gateway
Client
192.168.0.1/24
Gateway A
(main office)
LAN IP
192.168.0.1
Figure 64. Telecommuter example

Set Up Client-to-Gateway VPN (Telecommuter Example)

Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN client and a
network gateway involves two steps, described in the following sections:
• Step 1: Configure Gateway A (VPN Router at Main Office)
• Step 2: Configure Gateway B (VPN Router at Regional Office)
configuring the NETGEAR ProSafe VPN client endpoint.
Scenario 1
PC/client-to-gateway, with client behind NAT router
IKE with pre-shared secret/key (not certificate based)
Fully qualified domain name (FQDN)
Dynamic
WAN IP
Internet
FQDN
ntgr.dyndns.org
"from_GW_A"
NETGEAR VPN Configuration
167
Gateway B
(regional office)
WAN IP
0.0.0.0
IP: 192.168.2.3
"toGW_A"
on page 168.
on page 169 describes
.
Client PC
(running NETGEAR
ProSafe VPN client)