Craftsman 79481 - Professional 28cc 2 Cycle Gas Blower Operator's Manual page 10

7. Once the engine starts, allow it to
run 10 seconds, then move the
choke lever to the OFF CHOKE
(opened) position. NOTE: If engine
dies with the choke lever in the OFF
CHOKE (opened) position, move the
choke lever to the FULL CHOKE
(closed) position and pull the starter
rope handle until engine starts and
runs, but no more than 6 pulls.
STARTING A WARM ENGINE
1. Squeeze and hold the throttle trigger.
2. Move choke lever to HALF CHOKE
position.
3. Pull starter rope handle with a con-
trolled and steady motion while
squeezing throttle trigger until en-
gine starts and runs, but no more
than 6 pulls.
4. Allow engine to run 15 seconds,
then move choke lever to the OFF
CHOKE (opened) position.
NOTE: If the engine has not started,
pull starter rope handle 5 more pulls. If
engine still does not start and run, it is
probably flooded. Proceed to START-
ING A FLOODED ENGINE.
STARTING A FLOODED ENGINE
Flooded engines can be started by
placing the choke lever in the OFF
CHOKE (opened) position and fully
squeezing the throttle trigger. Pull the
starter rope handle repeatedly while
squeezing throttle trigger to clear the
engine of excess fuel. This could
require pulling the starter handle many
times, depending on how badly the
unit is flooded. If the unit still doesn't
start, refer to the TROUBLESHOOTING
TABLE or call 1-800-235-5878.
CUSTOMER RESPONSIBILITIES
WARNING: Disconnect the spark plug before performing maintenance,
service, or adjustments.
CARE & MAINTENANCE TASK
Check for loose fasteners and parts
Check for damaged or worn parts
Inspect and clean unit and labels
Clean air filter
Replace spark plug
WHEN TO PERFORM
Before each use
Before each use
After each use
Every 5 hours of operation
Yearly
WARNING: Avoid touching muf-
fler unless engine and muffler are cold.
A hot muffler can cause serious burns.
_:_WARNING: Stop engine and be
sure the impeller blades have stopped
turning before opening the vacuum in-
let door or attempting to insert or re-
move the vacuum or blower tubes.
The rotating blades can cause serious
injury. Always disconnect the spark
plug before performing maintenance or
accessing movable parts.
GENERAL RECOMMENDATIONS
The warranty on this unit does not cov-
er items that have been subjected to
operator abuse or negligence. To re-
ceive full value from the warranty, the
operator must maintain unit as instruct-
ed in this manual. Various adjustments
will need to be made periodically to
properly maintain your unit.
CHECK FOR LOOSE
FASTENERS AND PARTS
• Muffler
• Spark Plug Boot
• Air Filter
• Housing Screws
CHECK FOR DAMAGED OR
WORN PARTS
Contact Sears Service Center for re-
placement of damaged or worn parts.
• Fuel Tank - Do not use unit if fuel tank
shows signs of damage or leaks.
INSPECT AND CLEAN UNIT
AND LABELS
• After each use, inspect complete unit
for loose or damaged parts. Clean
the unit using a damp cloth with a
mild detergent.
• Wipe off unit with a clean dry cloth.
-10-