Maintenance Box; Checking The Maintenance Box Status; Handling Precautions - Epson WorkForce Pro WP-M4525 User Manual

User's Guide
D
Shake the ink cartridge for 5 seconds 15 times horizontally in approximately 5 cm movements as shown in the
following illustration.
E
Place the ink cartridge into the cartridge holder. Push the cartridge until it clicks into place, and then close the
front cover.
Note:
The power light continues to flash while the printer is charging ink. Do not turn off the printer during ink charging. If
the ink charging is incomplete, you may not be able to print.
Ink cartridge replacement is complete. The printer will return to its previous status.

Maintenance Box

Checking the maintenance box status

The maintenance box status is shown in the same screen of the ink cartridge status. You can check the status from the
printer software or the control panel.
"Checking the ink cartridge status" on page 122
&

Handling precautions

Read all of the instructions in this section before replacing the maintenance box.
❏ Epson recommends the use of a genuine Epson maintenance box. The use of a non-genuine maintenance box may
cause damage that is not covered by Epson's warranties, and under certain circumstances, may cause erratic
printer behavior. Epson cannot guarantee the quality or reliability of a non-genuine maintenance box.
❏ Do not dismantle the maintenance box.
❏ Do not touch the green IC chip on the side of the maintenance box.
❏ Keep out of reach of children, and do not drink the ink.
Replacing Consumables
127