Oki MB451wMFP User Manual page 50

Connecting to a Computer
Note
 There is not setting for the WEP KEY index. The WEP
KEY index communications with the wireless AP as 1.
b) Enter the same KEY as the WEP KEY set
for the wireless AP that you want to
connect to.
After entering the WEP KEY, move the
cursor to the [Done] field and press
Memo
 After entering the KEY, the key is displayed as "*"
symbols for security reasons.
(2) When WPA-PSK or WPA2-PSK is
selected:
a) Press the to select the encryption type,
and then press
Memo
 The default is [TKIP].
 Depending on the model of wireless AP, the mixed
TKIP/AES may be supported. In this case, we
recommend using AES.
b) Press the on the Pre Shared KEY input
screen.
Memo
 Nothing is set by default. If a Pre Shared KEY is
already set, "*" is displayed. When the [OK] button is
pressed, the screen switches to that shown in step 10
without switching to the screen shown in step c). If
the right button is pressed to switch to step c) when a
Pre Shared KEY is set, the set KEY is cleared.
c) Enter the same KEY as the Pre Shared KEY
set for the wireless AP that you want to
connect to.
After entering the Pre Shared KEY, move
the cursor to the [Done] field and
press .
OK
.
OK
Memo
 After entering the KEY, the key is displayed as "*"
symbols for security reasons.
In the confirmation screen, check the
10
entered SSID and selected security
settings.
If there are no problems, press the
.
select [Yes], and then press
OK
If [Yes] is selected in step 10,
11
[Searching for connection...] is
displayed in the screen.
When [Connection successful] is
displayed, this equipment is connected to
the wireless LAN.
Memo
 If [Timeout] is displayed, the connection destination
wireless AP may not have been found within the specified
time. Check the SSID, security settings, and KEY settings,
and retry.
 Reconnect to the wireless LAN
When the wireless is enabled, restart the wireless
function. If a problem has occurred in the wireless
AP communication or performance, the wireless
function can be restarted.
(If the wired is enabled, the wireless function is
enabled with the configured wireless settings.)
Log in as the administrator.
1
Press the
2
and then press the
- 50 -
OK
to select [Network Menu],
.
to
.