Starting Warm Engine; Stopping Engine - Echo PB-620 Operator's Manual

STARTING WARM ENGINE

The starting procedure is the same as Cold Start except DO NOT close
the choke.
1. Throttle Position/Stop Switch Button
Slide Throttle Position /Stop Switch Button (A) back to idle
position (first detent away from stop position).
2. Purge Bulb
Pump purge bulb (C) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
3. Recoil Starter
Pull recoil starter handle (D) and engine should start.
NOTE
If engine does not start after 5 pulls, use cold start procedures.

STOPPING ENGINE

1. Throttle Position/Stop Switch Button
Release throttle trigger. Move Throttle Position /Stop Switch
Button (A) forward to idle position (first detent away from stop
position) and allow engine to return to idle before shutting off
engine.
2. Throttle Position/Stop Switch Button
Move Throttle Position /Stop Switch Button (A) all the way
forward to STOP position.
WARNING
If engine does not stop when stop switch is moved to STOP
position, close choke - COLD START position - to stall engine.
Have your ECHO dealer repair stop switch before using blower
again.
P B
OWER LOWER
O ' M
PERATOR S ANUAL
A
C
D
A
13