Starting Cold Engine - Echo PB-620 Operator's Manual

12
After use
• DO NOT store a unit with fuel in its tank. Leaks can occur.
Return unused fuel to an approved fuel storage container.
Storage - Fuel storage laws vary by locality. Contact your local
government for the laws affecting your area. As a precaution, store
fuel in an approved, airtight container. Store in a well-ventilated,
unoccupied building, away from sparks and flames.

STARTING COLD ENGINE

• Recoil starter: Use short pulls - only 1/2-2/3 of rope length for
starting. Do not allow the rope to snap back in. Always hold the unit
firmly.
1. Throttle Position/Stop Switch Button
Slide Throttle Position /Stop Switch Button (A) back to idle
position (first detent away from stop position)
2. Choke
Move choke (B) up to Cold Start position (
3. Purge Bulb
Pump purge bulb (C) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
4. Recoil Starter
Pull recoil starter handle (D) until engine fires (5 pulls maxi-
mum).
5. Choke
Move choke (B) down to run position (
restart engine.
NOTE
If engine does not start after 5 pulls, move choke to "Cold Start"
position, and repeat steps 4 & 5.
NOTE
Allow engine to warm up before use.
).
), and if necessary,
IMPORTANT
Stored fuel ages. Do not mix more fuel
than you expect to use in thirty (30)
days, ninety (90) days when a fuel
stabilizer is added.
IMPORTANT
Stored two-stroke fuel may separate.
ALWAYS shake fuel container
thoroughly before each use.
A
B
C
D