Spark Plug; Cooling System - Echo PB-265L Operator's Manual

Echo power blower operator's manual
Hide thumbs Also See for PB-265L:
Table of Contents

Advertisement

SPARK PLUG

Level 2.
Tools required:
T-Wrench, Feeler gauge
Parts Required:
Spark plug
IMPORTANT
Use only NGK BPM8Y spark plug otherwise severe engine
damage may occur.
1. Remove spark plug and check for fouling, worn and rounded
center electrode.
2. Clean the plug or replace with a new one. DO NOT sand blast to
clean. Remaining sand will damage engine.
3. Adjust spark plug gap by bending outer electrode.
4. Tighten spark plug to 150-170 kg/cm (130-150 in. lb.).

COOLING SYSTEM

Level 2.
Tools required: 4mm x 130 mm (5") long hex wrench, cleaning brush
Parts Required: None, if you are careful.
IMPORTANT
To maintain proper engine operating temperatures, cooling air must
pass freely through the cylinder fin area. This flow of air carries
combustion heat away from the engine.
Overheating and engine seizure can occur when:
• Air intakes are blocked, preventing cooling air from reaching the
cylinder.
• Dust and grass build up on the outside of the cylinder. This build
up insulates the engine and prevents the heat from leaving.
Removal of cooling passage blockages or cleaning of cooling fins is
considered "Normal Maintenance." Any failure attributed to lack of
maintenance is not warranted.
Cleaning Grill and Cylinder Fins
1. Remove accumulated debris from intake grill between backpack
frame and blower housing.
2. Disconnect spark plug lead from spark plug.
P
B
OWER
LOWER
O
'
M
PERATOR
S
0.65 mm
(0.026 in.)
INTAKE GRILL
17
ANUAL

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents