Power Saver Mode - Epson AcuLaser M1400 Series User Manual

2. (Ready) LED
❏ Indicates the printer status such as ready to print.
3. Button
❏ Press this button to start duplex printing after loading paper.
❏ Press and hold this button during printing to cancel a print job.
❏ Press this button to exit the Power Saver mode.
❏ Press this button to continue a pending job in an error state such as misfeeding after checking
that paper is loaded properly.
The LEDs provide information on the status of the printer.
LED Status
Error Umber on
Umber blinks
Ready Green on
Green blinks
Green blinks slowly
See Also:
"Understanding the Operator Panel Lights" on page 54

Power Saver Mode

The printer has a power saving feature which reduces power consumption during periods of
inactivity. This feature operates in two modes: the Low Power mode and Sleep mode. As delivered, the
printer switches to the Low Power mode one minute after the last job is finished. The printer then
switches to the Sleep mode after another 10 minutes of inactivity. In the Power Saver mode, the
(Ready) LED blinks slowly.
The factory default settings of 1 minute (Low Power mode) and 10 minutes (Sleep mode) are
changeable within the range of 1 - 30 minutes (Low Power mode) and 6 - 11 minutes (Sleep mode). The
printer returns to the ready-to-print state in about 25 seconds when re-activated.
Epson AcuLaser M1400 Series
Condition
An error occurred.
A fatal error occurred.
The printer is ready to print.
The printer is receiving, printing, or waiting for print data.
The printer is in the Power Saver mode.
User's Guide
Basic Operation 14