Electrolux EHD8740FOK User Manual page 13

Problem
comes on.
comes on.
and a number come
on.
comes on.
comes on.
comes on.
comes on.
Possible
The Child Safety Device or
the Lock function oper-
ates.
No cookware is on the
cooking zone.
The cookware is incorrect. Use the correct cookware.
The diameter of the bot-
tom of the cookware is
too small for the cooking
zone.
The cookware do not cov-
er the cross.
There is an error in the ap-
pliance.
The electrical connection
is incorrect. The supply
voltage is out of range.
There is an error in the ap-
pliance because a cook-
ware boils dry. The over-
heating protection for the
cooking zones and the
Automatic Switch Off op-
erate.
The cooling fan is blocked. Check if objects block the
The electrical connection
is incorrect. The appliance
is connected only to one
phase.
ENGLISH
Remedy
Refer to the chapter "Op-
erating instructions".
Put cookware on the
cooking zone.
Use cookware with cor-
rect dimensions.
Cover the cross fully.
Disconnect the appliance
from the electrical supply
for some time. Disconnect
the fuse from the electrical
system of the house. Con-
nect it again. If comes
on again, speak to the
service centre.
Speak to a qualified elec-
trician to check the instal-
lation.
Deactivate the appliance.
Remove the hot cook-
ware. After approximately
30 seconds, activate the
cooking zone again. If the
cookware was the prob-
lem, the error message
goes out of the display,
but the residual heat indi-
cator can stay. Let the
cookware become suffi-
ciently cool and refer to
"Cookware for the induc-
tion cooking zone" to see
if your cookware is com-
patible with the appliance.
cooling fan. If comes
on again, speak to the
service center.
Connect the appliance as
you see it in the connec-
tion illustration.
13