Download Print this page

Chamberlain LiftMaster CSL24V Quick Start Manual

Elite series for single gate applications
Hide thumbs Also See for LiftMaster CSL24V:

Advertisement

QuickStart
This QuickStart is intended to highlight a single right-hand gate application. Each application is unique and it is the responsibility of the purchaser, installer and end user to ensure that the
total gate system is installed and operated properly. Refer to the installation manual for complete information regarding installation, testing, and programming.
INSTALLATION
1
Install the concrete pad and conduit.
2
Attach the operator to the concrete pad.
3
Attach the gate brackets to the gate.
4
Close the gate.
5
Route the chain through the operator.
6
Connect the chain to the gate brackets.
7
Remove the pin from the vent plug on the gear box.
3
6
for single gate applications
4
1
Close the gate BEFORE installing the chain.
2
6
MODEL CSL24V
INSTALL THE COVER
1
Align the tabs on the rear cover with the slots on the chassis
and place the cover over the operator.
7
2
Secure both sides of the rear cover to the chassis with two
5/16-18 hex bolts and washers.
3
Align the front cover with the back cover, making sure the
grooves line up.
4
Secure the front cover to the chassis with two 5/16-18 hex
bolts and washers.
5
Secure the front cover to the rear cover using the 5/16-18
screw.
5
5/16-18
Screw
Tabs on Rear Cover
3
& CSL24VH
5/16-18
Hex Bolts
and Washers
Slots on Chassis
Groove on Front Cover

Advertisement

loading

Summary of Contents for Chamberlain LiftMaster CSL24V

  • Page 1 QuickStart ™ ™ MODEL CSL24V & CSL24VH for single gate applications This QuickStart is intended to highlight a single right-hand gate application. Each application is unique and it is the responsibility of the purchaser, installer and end user to ensure that the total gate system is installed and operated properly.
  • Page 2 WIRING INITIAL LIMITS AND FORCE ADJUSTMENT Press and release the SET OPEN and SET CLOSE buttons simultaneously to enter limit setting mode. To protect against fire and electrocution: WIRE THE ENTRAPMENT PROTECTION DEVICES • DISCONNECT power and battery BEFORE Press and hold one of the MOVE GATE buttons to move the gate to the Connect the entrapment protection device to the EYES EDGE terminal on the control installing or servicing operator.

This manual is also suitable for:

Liftmaster csl24vh