Installation Requirements; Tools And Parts - KitchenAid KUDC10FXSS Installation Instructions Manual

Installation guide
Hide thumbs Also See for KUDC10FXSS:
Table of Contents

Advertisement

Available languages

Available languages

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the recommended tools and parts before starting
installation. Read and follow the instructions provided with
any tools listed here.
All Installations
Tools needed:
Flat-blade
Pliers
screwdriver
Phillips
Utility knife
screwdriver
"
"
UL Listed/CSA
Approved twist-on
nut drivers or
wire connectors*
hex sockets
Measuring tape
Small level
or ruler
10" adjustable wrench
"
that opens to
wrench
"
If installing custom front panels,
®†
Torx
T15 screwdriver
*Must be the proper size to connect your household wiring
to 16-gauge wiring in dishwasher
Other useful items you may need:
Flashlight
Bath towel
Shallow pan
Wood block
Parts supplied:
Drain hose
Drain hose
2 – under-
2 –
clamps (2)
counter
custom
Phillips-
mounting
tape
(1 large and
head
screws (2)
brackets (top)
1 small)
Make sure all these parts are included in the literature package.
Silver
Green
Parts needed:
4 #10 x ¹⁄₂" wood screws (if installing custom front panels)
†® TORX is a registered trademark of Saturn Fasteners, Inc.
Supplied in Kit:
4 Plastic studs (attached to each other by runners)
4 Short screws (10-16 hex head screw)
4 Long screws (8-18 Torx
®†
head screws)
1 Template (located inside Use and Care Guide bag
assembly)
1 Instruction sheet (located inside Use and Care Guide bag
assembly)
NOTE: The screws supplied are used for only ³⁄₄" thick
wooden panel. If the wooden panel is less than ³⁄₄" thick,
customer must purchase screws locally.
Other parts you may also need:
Masking or
Moisture
duct tape
barrier tape
(3.81–5 cm)
(Part Number
Screw-type
4396277).
clamps (3 maximum)
NOTE: Moisture barrier tape is recommended when installing a
dishwasher under a wood countertop.
NOTE: Parts available for purchase in plumbing supply stores.
Check local codes. Check existing electrical supply. See
“Electrical Requirements” section. It is recommended that
electrical connections be made by a licensed electrical installer.
In addition, for first-time installations
Tools needed:
Cordless drill
with ¹⁄₂", ³⁄₄"
and 1¹⁄₂" hole
Small
saw bits
Wire stripper
tubing cutter
Parts needed:
Copp
See “Electrical Requirements” section.
O.D. suggested) or
For Direct Wire:
For Power Supply
flexible braided
use UL Listed/
Cord: use UL
water supply line
CSA Approved
Listed/CSA
strain relief
Approved power
supply cord kit
hole
marked for use with
dishwasher
Additional parts supplied with top-venting models only:
®
"
Torx
T15 screws
"
Additional parts supplied with certain models only:
Bottom sound pad
(located in lower rack)
Make sure all these parts are included in the literature package.
If parts are not included, call 1-800-422-1230.
Page 3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents