Built-up floors: If the kitchen floor is higher than the
cabinet opening's floor - for example, the kitchen floor tile
does not extend into the cabinet opening - add shims as
needed in the area shown to bring the dishwasher up to
34 " (86.4 cm) below the countertop.
NOTE: Shims must be securely attached to floor to avoid
movement when the dishwasher is in use.
Install the Door Handle
(on some models)
Install door handle
Mounting stud
Handle
Setscrew
(in bottom
of handle)
Hex key
IMPORTANT: Do not scratch the front panel during this
procedure.
Remove the door handle and hardware bag containing the
setscrews and hex key from the cardboard box. Setscrews
are already installed in the handle. Place handle on
mounting studs with the setscrews facing down. Push the
door handle tightly against the door. Insert the short end
of the hex key into the setscrews. Tighten the setscrews ¹⁄₄
turn past snug.
Retain hex key with Installation Instructions.
Custom Panel Dimensions
Custom panel dimensions—Dishwashers
with control panel on the top
23⁵⁄₈"
*29²⁹⁄₃₂" (76 cm)
(60 cm)
*
This dimension is for 4" (10.2 cm) toe kick. If the
*
installation needs a higher toe kick, adjust the height
of the wood panel accordingly. Not recommended for
toe kicks greater than 6" (15.2 cm).
Page 14