Connecting The Optional Power Adapter; Inserting The Tape Cassette - Dymo LabelManager 220P User Manual

Connecting the Optional Power Adapter

An optional 9 Volt, 1.5 A power adapter can also be used to power the label maker.
Connecting the AC adapter disconnects the batteries as a power source.
To connect the power adapter
1. Plug the power adapter into the power connector on
the top, left side of the label maker.
2. Plug the other end of the adapter into a power outlet.
Ç Make sure the label maker power is turned off before
you disconnect the power adapter from the main power
source. Otherwise, your most recent memory settings
will be lost.

Inserting the Tape Cassette

Your label maker comes with one tape cassette.
You can purchase additional tape cassettes from
your local office supply retailer.
To insert the tape cassette
1. Lift the tape cassette cover to open the tape
compartment. See Figure 3.
Before using the label maker for the first
Ç
time, remove the protective cardboard insert
from the tape exit slot.
2. Insert the cassette with the label facing up and
the tape positioned between the guideposts.
3. Press firmly until the cassette clicks into place.
See Figure 5.
4. Close the tape cassette cover.
6
See Figure 4.
Guideposts
Remove
cardboard insert
Click!
Click!
Figure 3
Figure 4
Figure 5