A Message for the Client
FILTER
The model you have selected is shipped in 2 separate boxes to protect certain
components. The filter comes in one box, and the outer shell of the unit,
ASSEMBLY
containing the motor and the fan, comes in another. Filters must be installed
before turning the unit on in order for it to work. AllerAir technicians
D, DS, DX &
recommend removing the base, installing the filter, and replacing the base
according to the following steps:
6000 MODELS
Step 1
Step 2
Make sure the unit is set to "Off,"
Using a #2 Philips screwdriver,
and unplug it. Lay the unit upside
remove the four screws that hold
down, so that the wheels face up.
the base onto the unit.
Step 5
Gently insert the carbon filter
Step 4
(either a Model D, DS or DX Carbon)
into the unit, either end up.
Reach inside the unit, and remove
For 6000 Carbon/Hepa Models
only 1 of the 2 felt pads.
Insert carbon canister, then Hepa in
center
Step 7
Step 8
Replace the base, making sure the
Replace the four screws.
arrow on the gold sticker lines up
with unit's rear seam.
AllerAir Industries Inc.
Toll free: 1-888-852-8247 / Fax: 1-877-688-2193 www.allerair.com
Step 3
Grasp the wheels. Remove the base
by pulling gently on the wheels.
HEPA
NEW
CARBON
Step 6
Put back the felt pad removed in
STEP 4.
Step 9
Turn the unit back onto its wheels.
It is now ready for use.
A Message for the Client
FILTER
The model you have selected is shipped in 2 separate boxes to protect certain
components. The filter comes in one box, and the outer shell of the unit,
ASSEMBLY
containing the motor and the fan, comes in another. Filters must be installed
before turning the unit on in order for it to work. AllerAir technicians
D, DS, DX &
recommend removing the base, installing the filter, and replacing the base
according to the following steps:
6000 MODELS
Step 1
Step 2
Make sure the unit is set to "Off,"
Using a #2 Philips screwdriver,
and unplug it. Lay the unit upside
remove the four screws that hold
down, so that the wheels face up.
the base onto the unit.
Step 5
Gently insert the carbon filter
Step 4
(either a Model D, DS or DX Carbon)
into the unit, either end up.
Reach inside the unit, and remove
For 6000 Carbon/Hepa Models
only 1 of the 2 felt pads.
Insert carbon canister, then Hepa in
center
Step 7
Step 8
Replace the base, making sure the
Replace the four screws.
arrow on the gold sticker lines up
with unit's rear seam.
AllerAir Industries Inc.
Toll free: 1-888-852-8247 / Fax: 1-877-688-2193 www.allerair.com
Step 3
Grasp the wheels. Remove the base
by pulling gently on the wheels.
HEPA
NEW
CARBON
Step 6
Put back the felt pad removed in
STEP 4.
Step 9
Turn the unit back onto its wheels.
It is now ready for use.
Docs_on_Pdf/Filter_assembly/New_with_6000 June 2007