Power Management Setup - Gigabyte GA-78LMT-S2PT User Manual

ECP Mode Use DMA
&
Selects DMA channel for the LPT port in ECP mode. This item is configurable only if Parallel Port Mode
is set to ECP or ECP+EPP mode. Options are: 3 (default), 1.
2-7

Power Management Setup

CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
ACPI Suspend Type
Soft-Off by Power button
USB Wake Up from S3
Modem Ring Resume
PME Event Wake Up
HPET Support
(Note)
Power On By Mouse
Power On By Keyboard
x KB Power ON Password
AC Back Function
Power-On by Alarm
x Date (of Month)
x Resume Time (hh:mm:ss)
ErP Support
: Move Enter: Select
F5: Previous Values
ACPI Suspend Type
&
Specifies the ACPI sleep state when the system enters suspend.
S1(POS) Enables the system to enter the ACPI S1 (Power on Suspend) sleep state. In S1 sleep

state, the system appears suspended and stays in a low power mode. The system can
be resumed at any time.
S3(STR) Enables the system to enter the ACPI S3 (Suspend to RAM) sleep state (default). In

S3 sleep state, the system appears to be off and consumes less power than in the S1
state. When signaled by a wake-up device or event, the system resumes to its working
state exactly where it was left off.
Soft-Off by Power button
&
Configures the way to turn off the computer in MS-DOS mode using the power button.
Instant-Off Press the power button and then the system will be turned off instantly. (Default)

Delay 4 Sec. Press and hold the power button for 4 seconds to turn off the system. If the power

button is pressed for less than 4 seconds, the system will enter suspend mode.
USB Wake Up from S3
&
Allows the system to be awakened from ACPI S3 sleep state by a wake-up signal from the installed USB
device. (Default: Enabled)
Modem Ring Resume
&
Allows the system to be awakened from an ACPI sleep state by a wake-up signal from a modem that
supports wake-up function. (Default: Disabled)
PME Event Wake Up
&
Allows the system to be awakened from an ACPI sleep state by a wake-up signal from a PCI or PCIe
device. Note: To use this function, you need an ATX power supply providing at least 1A on the +5VSB lead.
(Default: Enabled)
HPET Support
& (Note)
Enables or disables High Precision Event Timer (HPET) for Windows 7/Vista operating system.
(Default: Enabled)
(Note) Supported on Windows 7/Vista operating system only.
Power Management Setup
[S3(STR)]
[Instant-off]
[Enabled]
[Disabled]
[Enabled]
[Enabled]
[Disabled]
[Disabled]
Enter
[Soft-Off]
[Disabled]
Everyday
0 : 0 : 0
[Disabled]
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
- 32 -
Item Help
Menu Level `
ESC: Exit F1: General Help
F7: Optimized Defaults