Tecumseh HH100 Handbook page 60

3. With the toggle switch in the "off" position, the
test light will light.
4. With the toggle switch in the "on" position, the
test light will not light.
5. Position the spade connectors to the original
positions.
DISCONNECT FROM BATTERY
ON-OFF TOGGLE SWITCH
(RED LEAD)
(RED
LEAD)
CONNECTOR
BATTERY POWERED CONTINUITY TESTER
B. Test for switch continuity of D.C. circuit.
1. Disconnect the spade connector (red wire)
from the switch terminal.
2. Disconnect the other spade connector (red
wire) from the switch terminal.
3. Place continuity tester probes on each switch
terminal.
4. With the toggle switch in the "on" position the
test light will light.
5. With the toggle switch in the "off" position the
test light will not light.
6. Position the spade connectors to the original
positions.
DISCONNECT FROM BATTERY
ON-OFF TOGGLE SWITCH
CONNECTOR
BATTERY POWERED CONTINUITY TESTER
REMOVE WIRES FROM STARTER SWITCH TERMINALS
If either of the tests do not give the correct results,
replace the switch.
58
STARTER
SWITCH
FUSE
GROUND
DISCONNECT FROM
STARTER
STARTER
SWITCH
FUSE
GROUND
STARTER SWITCH CONTINUITY TEST. Remove wires
from starter switch. Place test leads on to switch
terminals. No continuity should exist (Test light should
not light). Leave test leads attached; depress starter
button. Continuity should exist (Test light should light).
If starter switch fails either of these tests, replace
switch.
PUSH IN
TURN CCW
REMOVE
FUSE (30 AMP)
(3 AG)
FUSE. To remove the fuse, push the cap in to compress
spring at base of fuse holder and with same motion
turn the cap counterclockwise (ccw) and pull cap
away from holder. Fuse can now be removed from
holder. Inspect condition of fuse. If in doubt, perform
continuity test on fuse and/or connections in fuse
holder. To reinstall, reverse disassembly procedure.
If fuse is defective, replace with a 12 volt/30 amp.
size. (3 AG)
ON (POSITION)
NO. 14 WIRE (RED)
RED
GREEN
OFF (POSITION)
NO. 12 WIRE (RED)
NO. 16 WIRE (GREEN)
WIRING DIAGRAM. The wiring diagram is shown
to show the correct placement of electrical connections,
color code and wire gauge. The wire to the battery
is supplied by the O.E.M.
SPRING
STARTER SWITCH
TO BATTERY
NO. 6 WIRE
FUSE
NO. 6
WIRE
TO STARTER