Attaching Blade Guard/Splitter Assembly - Delta SHOPMASTER SM200L Instruction Manual

ATTACHING BLADE HEIGHT ADJUSTING HANDWHEEL
1. Insert an M6x1x55mm pan head screw (D) Fig. 5 through the handle (E). Attach the handle (E) to the handwheel
(A) by threading the screw (D) clockwise into the handwheel.
2. Attach the handwheel (A) Fig. 6 to the shaft (B). Align the flat on the inside of the handwheel to the flat on the shaft.
3. Fasten the handwheel (A) Fig. 7 to the shaft using an
M6x1x12mm flat head screw (C)
ATTACHING BLADE GUARD AND SPLITTER ASSEMBLY
DISCONNECT MACHINE FROM POWER
SOURCE.
PROPERLY ALIGN THE BLADE GUARD
AND SPLITTER ASSEMBLY WITH THE
SAW BLADE TO PREVENT KICKBACK.
1. Position the blade 90 degrees to the table and lock
in place.
2. Fasten the splitter support bracket (A) Fig. 9 to the
splitter bracket (B) using two 1/4-20x1/2" hex head
screws (C) and two 1/4" external tooth lockwashers
(D).
NOTE: Loosely tighten the screws for further
adjustment.
A
E
D
Fig. 5
A
A
A
C
11
Fig. 6
C
Fig. 7
B
D
Fig. 9
B