Troubleshooting Remote Shifter Unit - MINOURA MAGTURBO ERGO Manual

Table of Contents

Advertisement

<Trouble Shooting Your Remote Shifter Unit>
If you experience your load level increasing automati-
cally, the remote shifter lever may be loose.
To solve this problem, adjust the small center knob nut
on the remote shifter device. (see Fig. H)
If you cannot shift to either the lowest (L) or the highest
(H) position, it is possible that the inner wire of the re-
mote shifter cable is too long and the wire tension is
loose. If so, please adjust the tension with the following
steps;
1.
Set the remote shifter lever at "H" position. Remove the
remote shifter device from the handlebar and straighten
the cable.
2.
Remove the plastic cap located on the bottom of the cable.
(see Fig. I )
3.
Hold the adjusting screw with your right hand and push
it towards the direction of the outer cable, then adjust
the nut with your left hand to make the wire tension
properly.
- 7 -
Adjuster Nut
(Fig. H)
Nut
Plastic Cap
Cable
Wire Tension
Adjusting Screw
(Fig. I)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents