Analog Audio Cables; Digital Audio Cables; Video Cables - Pioneer VSX-822-K Operating Instructions Manual

Owner's manual
Hide thumbs Also See for VSX-822-K:
Table of Contents

Advertisement

2
2
Note
®
Use a High Speed HDMI
cable. If HDMI cable other than
®
a High Speed HDMI
cable is used, it may not work
properly.
When an HDMI cable with a built-in equalizer is connected,
it may not operate properly.
3D, Deep Color, x.v.Color signal transfer and Audio Return
Channel are only possible when connected to a compatible
component.
HDMI format digital audio transmissions require a longer
time to be recognized. Due to this, interruption in the audio
may occur when switching between audio formats or
beginning playback.
Turning on/off the device connected to this unit's HDMI
OUT terminal during playback, or disconnecting/
connecting the HDMI cable during playback, may cause
noise or interrupted audio.
HDMI, the HDMI Logo and High-Definition Multimedia
Interface are trademarks or registered trademarks of HDMI
Licensing, LLC in the United States and other countries.
"x.v.Color" and
are trademarks of Sony
Corporation.

Analog audio cables

Use stereo RCA phono cables to connect analog audio
components. These cables are typically red and white, and
you should connect the red plugs to R (right) terminals and
white plugs to L (left) terminals.
White (Left)
L
A U D
R
Red (Right)

Digital audio cables

Commercially available coaxial digital audio cables or optical
cables should be used to connect digital components to this
receiver.
Coaxial digital
audio cable
Note
When connecting optical cables, be careful when inserting
the plug not to damage the shutter protecting the optical
socket.
When storing optical cable, coil loosely. The cable may be
damaged if bent around sharp corners.
You can also use a standard RCA video cable for coaxial
digital connections.

Video cables

Standard RCA video cables
These cables are the most common type of video connection
and are used to connect to the composite video terminals. The
yellow plugs distinguish them from cables for audio.
I O
Component video cables (VSX-1022 only)
Use component video cables to get the best possible color
reproduction of your video source. The color signal of the TV is
divided into the luminance (Y) signal and the color (P
signals and then output. In this way, interference between the
signals is avoided.
C O A
X I A
L
I N
O P T
I C A
L
I N
Optical cable
V I D
E O
Yellow
15
Connecting your equipment
C O
M P
O N
E N
Y
T V
I D E
P
O
B
P
Green (Y)
R
Red (P
)
Blue (P
)
R
B
and P
)
B
R

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vsx-1022-k

Table of Contents