Network; Lan - TP-Link TL-WR720N User Manual

Note:
1) The WPS LED on the Router will light green for five minutes if the device has been
successfully added to the network.
2) The WPS function cannot be configured if the Wireless Function of the Router is disabled.
Please make sure the Wireless Function is enabled before configuring the WPS.
4.5

Network

Figure 4-5 the Network menu
There are three submenus under the Network menu (shown in Figure 4-5 ): LAN, WAN and MAC
Clone. Click any of them, and you will be able to configure the corresponding function.
4.5.1

LAN

Choose menu "Network→LAN", and then you can configure the IP parameters of the LAN on the
screen as below.
MAC Address - The physical address of the Router, as seen from the LAN. The value can't
be changed.
IP Address - Enter the IP address of your Router or reset it in dotted-decimal notation
(factory default: 192.168.0.1).
Subnet Mask - An address code that determines the size of the network. Normally use
255.255.255.0 as the subnet mask.
Note:
1. If you change the IP Address of LAN, you must use the new IP Address to login the Router.
2. If the new LAN IP Address you set is not in the same subnet, the IP Address pool of the
DHCP server will change accordingly at the same time，while the Virtual Server and DMZ
Host will not take effect until they are re-configured.
TL-WR720N
Figure 4-6 LAN
-19-
150Mbps Wireless N Router