Swashplate Type Setting / 十字盤模式設定; Swashplate & Servo Movement Setting / 十字盤及伺服機動作設定 - THUNDER TIGER TITAN X50 Instruction Manual

Swashplate Type Setting /
Set the model type for helicopter in your Transmitter and set the swashplate
type as 120°CCPM. Refer your Transmitter manual to find a proper
swashplate setting.
請參閱遙控器說明書，設定正確之十字盤設定模式。
Swashplate & Servo Movement Setting /
As going through these setup procedures, ensure there is none of the controls bind at full travel.
Next, please refer below illustrations to ensure the direction of servo movement and swash mixing settings are correct
for the controls properly.
在繼續設定之前，請先確認伺服機及連桿作動皆順暢可達最大作動量。
然後，請參考下表圖示，確認伺服機動作及十字盤混控設定可正確對應撥桿動作。
Model 1
Aileron
副翼
Elevator
升降舵
Pitch
螺距
Throttle
油門
Rudder
尾舵
If the movements of servos or swashplate are not correct, please adjust the servo reverse settings for one or more
channels in your Transmitter.
若伺服機或十字盤作動方向不正確，請調整您遙控器上個別的伺服機逆轉功能。
Model 2
Right Side/右側
Right Side/右側
Left Side/左側
Right Side/右側
Servo Horn movement
伺服機擺臂動作
Right Side/右側 Left Side/左側
Right Side/右側 Left Side/左側
-33-
Nose / 機首方向
120°
120° 120°
Check Point
機構動作確認
Front View / 前視圖
Right View / 右視圖
Front View / 前視圖