Configuring The Titan X50 / Titan X50 設定 - THUNDER TIGER TITAN X50 Instruction Manual

Configuring The Titan X50 / Titan X50
25.1mm
60mm
55mm
62.2mm
62.2mm
The above pushrod lengths permit 3D flying with the Titan X50.
Use these lengths as a starting point. Pushrod lengths are measured from ball link center to ball link center. Suggested
throttle and collective pitch set up: Idle-up1 is for continuous 3D flying and aerobatics. Idle-up2 is for those who have
very good collective pitch management skills. Use a pitch gauge to check blade angles. It is easier to start setting up
idle-up2 blade pitch angles first. For safety, to inhibit idle-up modes and just use a normal mode setting for a novice is
recommended. The model should hover at around 1550 rpm in normal mode, and flies at around 2000rpm in idle-up1/2.
With 1700 or higher headspeed, the use of carbon/FRP blades is recommended.
以上為 Titan X50 直昇機之3D飛行連桿長度設定值。這些設定值可作為初始設定時之參考標準。
在螺距及油門曲線設定方面，建議設定兩個特技模式。進行連續3D飛行時使用特技模式-1，而進行倒飛練習時則可使用特技模式-2
。此外，建議初學者暫時不要使用特技模式進行練習。
至於轉速的設定方面，建議停懸及特技模式之轉速分別為1550rpm及2000rpm。
建議當轉速高於1700rpm以上時，請將主旋翼更換為玻璃纖維或碳纖維主旋翼。切記！即便使用高性能碳纖維主旋翼，轉速仍有其
上限，請參照旋翼的使用說明，切勿超轉使用。
35.4mm
55mm
55.1mm
59.7mm
78.4mm
-29-
5-Point Throttle Curves
5點油門曲線
Normal 正常模式 0
Idle-up1 特技模式1 100
Idle-up2 特技模式2 100
5-Point Pitch Curves
點螺距曲線
Normal 正常模式 35
Idle-up1 特技模式1 10
Idle-up2 特技模式2 0
Hold 熄火降落 0
Blade Pitch Angles (degrees)
螺距角度
Normal 正常模式 -4
Idle-up1 特技模式1 -12
Idle-up2 特技模式2 -15
Hold 熄火降落 -15
The settings may differ, the table
is for your reference only.
每人操作習慣或有不同，僅供參考。
Length
measured from
ball link center
to
ball link center
由此連桿頭中心
測量至另一頭
連桿頭中心
35 50 65 100
85 60 85 100
85 60 85 100
- 70 - 85
- - - 90
- - - 100
- - - 100
6 10
0 12
0 15
15
0