THUNDER TIGER DUCATI 999R Testastretta Manual page 3

1
INSTALLING THE ELECTRIC MOTOR AND
ELECTRIC SPEED CONTROLLER
a
d
g
j
a.
Remove the bike's front suspension by disassembling the "E" clips on the steering shaft.
b.
Remove the shaft that holds the front steering mount and front fork shocks.
c.
Lift the entire set and remove it from the motorbike's assembly.
d.
Tighten the motor pinion with hexagon screw
e.
Install the motor mount and motor unit onto the side chassis by treading two internal hexagon screws
through the washers and motor mount.
f.
Use a thin sheet of paper and insert it between both gears to set proper gear mesh.
g.
Tape the E.S.C. to the top of the battery tray by using the supplied double-sided tape.
h.
Install the E.S.C. switch onto the left side of the chassis frame by using a piece of appropriated double-
sided tape
i.
Solder the E.S.C. black/red wire to the terminals on the motor. (Note: The red wire to the positive
terminal, black wire to the negative terminal)
j.
Reassemble the front suspension assembly.
b
e
h
2
skip if already assembled
c
f
i