Switching Between Dual And Single Mode; Remote Control - Dish Network VIP 722 User Manual

Switching Between Dual and Single Mode

Put the satellite receiver in Single or Dual Mode by pressing the front panel MODE button. Keep
the following items in mind when switching the satellite receiver between Dual and Single Mode:
Indications
Recording
Favorites
Lists
Locks
Closed
Captioning
Note: If someone is viewing the remote TVs while the receiver is in Dual Mode, you will see a
popup on the nearby TV warning you that you are about to disrupt the use of the TV2 outputs.

Remote Control

The two remote controls give you access to all the features of your satellite receiver. You can set
up each remote to control the satellite receiver and up to three other devices (see page 75). These
devices can be a TV, a VCR or DVD player, and a third device.
This section describes how to use the various features on the two types of remote controls
included with your satellite TV system.
Dual Mode
Dual Mode front panel
indicator lights.
The Recording front panel
indicator lights to show
whether TV1, TV2, or both
are currently recording.
Favorites Lists set up for
both outputs (TV1 and TV2)
are available.
Locks set up for both outputs
(TV1 and TV2) are available.
Closed Captioning (CC)
from SD and HD
programming is available on
TV1. CC from only SD
programming is available on
TV2 (CC must be enabled
on the TV).
Satellite Receiver
Remote Control
Single Mode
Single Mode front panel
indicator lights.
The TV1 Recording front
panel indicator lights when
you are recording from one
or both tuners.
Only Favorites Lists set up
for TV1 are available. The
lists for TV2 are not lost,
they are simply unavailable
in Single Mode.
Locks set up for only TV1
are available. The locks for
TV2 are not lost, they are
simply unavailable in Single
Mode.
Closed Captioning from the
receiver is available on
both outputs (TV1 and
TV2).
15