Summary of Contents for KUSSMAUL Auto-Pump 091-9HP
Page 1
AUTO-PUMP HP 120 VAC HIGH PRESSURE AIR COMPRESSOR SYSTEM MODEL #091-9HP INPUT: 120 volt, 60 Hz, 4.0 AMPS 1 YEAR WARRANTY KUSSMAUL ELECTRONICS CO., INC 170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796 TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857 FAX: 631-567-5826...
Page 2
INTRODUCTION The 091-9HP Auto-Pump Air Compressor system is a 120 volt 60 Hz split capacitor A.C. motor operating a single cylinder air compressor designed specifically for installation on vehicles with air brakes. During long idle periods of the vehicle when even the slightest seepage can cause an air brake system pressure to drop below the brake lockup pressure, the Auto Pump automatically starts to maintain the pressure.
Page 3
CAUTION NO CONDENSATE OR WATER MUST BE ALLOWED TO ENTER OR ACCUMULATE IN THE OUTPUT OF THE AUTO PUMP. ROUTE OUTPUT PRESSURE LINE DOWNWARD FROM AUTO PUMP TO PERMIT MOISTURE TO DRAIN AWAY. CONDENSATE TRAP MUST BE DRAINED WEEKLY WATER IN THE PUMP OUTLET WILL INDUCE FAILURE ! WATER DAMAGE WILL...
Page 4
7. Mount the air compressor. Connect a suitable piece of flexible tubing from the outlet port of compressor to the air tank . (Tubing and connectors are not supplied.) 8. An optional Mounting Plate 091-9HP-H is available to reduce any vibration and noise from the Auto Pump and to simplify pump mounting.
VEHICLE WIRING INSTALLATION 1. The Auto Pump is supplied with a 120 volt A.C. line cord and is ready to operate. The line cord may be plugged into an available outlet or the cord may be cut and permanently wired to the 120 volt A.C.
Page 6
FOR SIMPLIFIED MOUNTING WARRANTY All Auto Pumps of Kussmaul Electronics Company Inc. are warranted to be free of defects of material or workmanship. Liability is limited to repairing or replacing at our factory, without charge, any material or defects which become apparent in normal use within 1 year from the date the equipment was shipped.