Sign in today to find solutions:

Don't have an account? Sign up

 
BOOK# 091-9-1000 pump plus-reva
4-16-2002
INSTRUCTION MANUAL
AUTO CHARGE 1000
PUMP-PLUS
AIR COMPRESSOR / BATTERY CHARGER
MODEL #091-9-1000
NOTE :
This charger is designed for
vehicles with single battery system
and negative ground.
INPUT :120 volt, 50/60 Hz, 3.5 amps
OUTPUT: 18 AMPERES
1 YEAR WARRANTY ON AIR COMPRESSOR
3 YEAR WARRANTY ON CHARGER
.
KUSSMAUL ELECTRONICS CO., INC
170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796
TEL: in NY 631-567-0314
TOLL FREE: 800-346-0857
FAX: 631-567-5826
Next page ->

Summary of Contents

  • Page 1

    BOOK# 091-9-1000 pump plus-reva 4-16-2002 INSTRUCTION MANUAL AUTO CHARGE 1000 PUMP-PLUS AIR COMPRESSOR / BATTERY CHARGER MODEL #091-9-1000 NOTE : This charger is designed for vehicles with single battery system and negative ground. INPUT :120 volt, 50/60 Hz, 3.5 amps...

  • Page 2

    Introduction The AUTO CHARGE 1000 Pump Plus is a compact, completely automatic, single channel battery charger designed for vehicles with a single battery system. The charger is ruggedized to withstand the shock and vibration encountered by vehicle mounted equipment. The Auto Charge 1000 Pump Plus operates an 091-9 air compres- sor.

  • Page 3

    Battery Saver & Indicator A 3 ampere BATTERY SAVER is built into the charger. When connected as shown in the installation wiring diagram, loads on the battery such as radios and rechargeable hand lights are automatically switched to the BATTERY SAVER when power is applied to the charger.

  • Page 4

    Installation Wiring Diagram NOTE: INDICATOR WIRING, PIN 1 OF INDICATOR MUST GO TO PIN 1 OF CHARGER, PIN 2 OF INDICATOR TO PIN 2 OF CHARGER AND SO FORTH. PLEASE CHECK CONNECTORS AND COLOR OF WIRES BEFORE PLUGGING Auto Charge 1000 Pump Plus PUMP PLUS 1000 1 1 1 1 1...

  • Page 6

    Specifications: Input: 120 volt, 50/60 Hz, 3.5 amperes Input Fuse: 6 ampere, fast acting Output: 12 volts D.C. 15 amperes Max. Remote Sensing: Electronic, sense wires not required Number of Charger Outputs: 1 Number of Battery Saver Outputs: 1 Battery Saver Output: 12 volts D.C., 3 amperes Max. Indicators: Power: Red LED, indicates 120 volts power applied Battery Saver Overload: Yellow LED, indicates Battery Saver...

  • Page 7

    Kussmaul Electronics Company, Inc. shall have no liability for dam- ages of any kind to associated equipment arising from the installation and /or use of the Kussmaul Electronics Company, Inc. products. The pur- chaser, by the acceptance of the equipment, assumes all liability for any damages which may result from its installation, use or misuse, by the purchaser, his or its employees or others.

  • Page 8

    INDICATOR INSTALLATION 1. Locate Indicator in a convenient place on the vehicle. 2. Place the template in position and center punch in 4 places. 3. Drill holes as shown. 5. Cut out square hole. 6. Connect wiring to charger using butt connector supplied. 7.

Comments to this Manuals

Symbols: 0

Latest comments:

×

Select the desired size and copy embed code

Copy your embed code and put on your site: