Visioneer ROAD WARRIOR User Manual page 35

26 V S
ISIONEER TROBE
XP S U ' G
CANNER SER S UIDE
Note: If the page does not back out of the scanner, the calibration
may not have finished properly. Remove the page and complete the
installation of your scanner, then see the section, "Recalibrating or
Cleaning Your Scanner" on page 140 to run the calibration again.
4. Remove the sheet and replace it in its plastic bag.
Do not discard the calibration sheet. You may need it periodically
to calibrate the scanner to keep it operating at peak performance.
5. For Windows XP users only, click Finish on the Completing the
Found New Hardware Wizard window.
Do not proceed until you receive a message that your computer has
found the new hardware, or updated the driver database. If your
computer is running Windows XP, you will see the following message.