Programming The Spa Functions - Dimension One Spas home Series Owner's Manual

Control
8
9

Programming the Spa Functions

To initiate the programming sequence at any time, push and hold the PROGRAM button for 3 seconds. If within 10
seconds you do not proceed with programming, the spa will automatically exit the programming sequence and revert to
the pre-set factory default settings. To exit the programming sequence at any time, do not press any button for 10
seconds. Any programming changes made up to that point are saved.
Filter Cycle Duration
When you press Program button you will be prompted to set the Filter Cycle Duration. This tells your spa how long to
run during each filter cycle. Use the UP or DOWN Buttons to choose from 60, 90, 120, 150, or 180 minutes. The
factory default is 60 minutes. After setting the desired duration, press the Program button again to move to the next step.
Number of Filter Cycles
After setting the Filter Cycle Duration, you'll be prompted for the Number of Filter Cycles that your spa will run each
day. Use the Up and Down buttons to choose 1, 2, 3, or 4 cycles per day. The factory default is 2 times per day. Then
press the Program button to move on to the next step.
Bear in mind that the spa considers the "Start Time" of the first filter cycle to be one minute after its power is turned on.
If you'd like to change the starting time of the first filter cycle (and therefore all subsequent cycles), turn the spa power
off and then on at the desired time of day to reset it. (Note: if you turn the spa off and back on, you'll need to reset the
programming functions because the loss of power will return them to factory default settings).
10
Dimension One Spas – @Home Series Owner's Manual
8.TEMPERATURE Buttons
You control the water temperature with the Up (+) and Down (-) Buttons.
Push a button once to change the temperature by one degree, or hold it down to
rapidly change it by many degrees. For your safety, the temperature can be set
no higher than 104 ° F (40° C).
While you are setting the temperature, the Set Point light on the Control Panel
will glow to indicate that the display is showing the desired Set Temperature
and not the actual temperature.
After you have set the desired temperature, the Display Window will revert to
showing the actual water temperature. The hot tub will heat to the new Set
Temperature automatically.
9.
PROGRAM Button
You push the PROGRAM Button to begin the process of programming the
spa functions. See the section on "Programming the Spa Functions" for details.
To initiate the programming sequence at any time, push and hold the
PROGRAM button for 3 seconds. If within 10 seconds you do not proceed
with programming, the spa will automatically exit the programming sequence
and revert to the pre-set factory default settings. To exit the programming
sequence at any time, do not press any button for 10 seconds. Any
programming changes made up to that point are saved.
Function