DigiTech HardWire RV-7 Owner's Manual

DigiTech HardWire RV-7 Owner's Manual

Digitech stereo reverb owner's manual

Advertisement

Advertisement

Table of Contents
loading

Summary of Contents for DigiTech HardWire RV-7

  • Page 2 Directive 2004/108/EC. Vice-President of Engineering 8760 S. Sandy Parkway Sandy, Utah 84070, USA Date: June 10, 2008 European Contact: Your local DigiTech Sales and Service Office or: Harman Music Group 8760 South Sandy Parkway Sandy, Utah 84070 USA Ph: (801) 566-8800...
  • Page 3 The foregoing is in lieu of all other warranties, expressed or implied, and DigiTech neither assumes nor authorizes any person to assume any obligation or liability in connection with the sale of this product. In no event shall DigiTech or its dealers be liable for special or consequential damages or from any delay in the performance of this warranty due to causes beyond their control.
  • Page 5: Included Items

    Introduction More than a remarkable achievement, HardWire significant improvements in effects pedals for guitar. HardWire pedals pro- vide a suite of well-known effects, each with superior tone and control. But these pedals go above and beyond their peers, providing such distinguishing...
  • Page 7 What Does This Do? Level Knob - Controls the reverb level. Turn this knob clockwise to increase and counter-clockwise to decrease the reverb level. DC Adapter Jack - Connect (an optional) Harman PS00R power supply to this jack. Use the proper supply for your area’s mains line voltage.
  • Page 8 REVERSE - reverb in reverse; quietly crescendos to full volume. MODULATED - lush modulating reverb ideal for chords. GATED - unique reverb with abrupt decay; good for percussive HALL - large encompassing reverb with warm decay. SPRING - classic “surf ” reverb; great for Rockabilly too! Input 1 (Mono) - Connect your instrument, the output of a pedal, or an amp effects send to this jack.
  • Page 9 Output 1 (Mono) - Connect this output to the input of a single guitar amplifier or amp effects return. Output 2 - Connect this output to the input of a second guitar amplifier when a second amp is being used.
  • Page 10 The Tails Switch is located under the Foot Switch and is accessed by press- ing in one of the Foot Switch Release Pins using the tip of a /" guitar cable plug. Once the Foot Switch is removed, the Tails Switch is visible inside the chassis next to the button switch that turns the effect on and off.
  • Page 12 Amplifier Setup PS200R (optional)
  • Page 13 Effects Setup Note: If the amp effects loop has a mix control, set the mix to 100% full wet. AMP RETURN PS200R (optional) AMP SEND...
  • Page 14 To replace the battery, do the following: Using the tip of a /” guitar cable, push one of the Release Pins in on either side of the Foot Switch, and remove it from the pedal chassis.
  • Page 15 Switch is properly fastened, both release pins are flush with the outer side of the pedal. Foot Switch Pedal Switch Foot Switch Release Pin Battery Compartment Spring 9VDC Battery Foot Switch Release Pin Pedal Chassis...
  • Page 16 HardWire Performance Accessories The performance accessories make integrating a HardWire pedal into any pedal board a snap. The following accessories are included: • Hook-and-loop Pedalboard Pad (designed to attach to the surfaces found on most commercial pedalboards) • Foot Switch Glow Sticker (easily visible on dark stages) •...
  • Page 17 Hook-and-loop Pedalboard Pad To attach the Pedalboard Pad, do the following: Peel off the existing rubber skid pad from the bottom of the pedal. Peel the adhesive protector from the back of the Pedalboard Pad. Apply the Pedalboard Pad to the bottom of the pedal.
  • Page 18 Foot Switch Glow Sticker To attach the Foot Switch Glow Sticker, do the following: Peel the adhesive backing from the Foot Switch Glow Sticker. Apply the Glow Sticker to the top of the Foot Switch.
  • Page 19 StompLock To place the StompLock over the pedal knobs, do the following: Set the knobs to your preferred setting. Gently push the StompLock over the top of the knobs. To remove the StompLock, gently lift one side and then the other.
  • Page 20: Specifications

    Specifications Controls - Level, Liveliness, Decay, Type, On/Off Pedal Jacks - Input  (Mono), Input , Output  (Mono), Output  Input Impedance - > MΩ (stereo), >00 kΩ (mono) - effect on Output Impedance -  kΩ - effect on Input Impedance - true hardwire bypass - effect off Output Impedance - true hardwire bypass - effect off Power Supply - V Alkaline Dry Battery or...
  • Page 24 8760 South Sandy Parkway Sandy, Utah 84070 PH (801) 566-8800 FAX (801) 566-7005 HardWire and DigiTech are trademarks of the Harman Music Group Inc. Copyright - Harman Music Group Manufactured in the USA HardWire RV-7 Owners Manual 18-0488-A Please visit us on the World Wide Web at: www.digitech.com...

Table of Contents