Belkin F1DF102U - Flip USB KVM Switch Installation Instructions

Package Contents
• Remote
• KVM Switch with Cables
Introduction
Congratulations and thank you for purchasing Flip. Flip is easy to set
up and use, and comes with everything you need to share one monitor,
keyboard, and mouse between your two computers. No additional
cables or software are required.
The diagram below shows a typical Flip setup. The remote sits on your
desk and connects—along with your monitor, keyboard, and
mouse—to the KVM switch. The KVM switch is connected to your
two computers.
Package Contents/Introduction 1
System Requirements
Monitor
Flip supports any LCD or CRT monitor with a VGA connection.
You can also use your DVI monitor with Flip by connecting a VGA
adapter to the DVI cable. Flip does not support direct DVI connections
from monitors.
VGA connection
Keyboard/Mouse
Flip supports any keyboard and mouse with a USB connection.
USB connection
Computers
Flip can be used with any PC or Mac desktop or notebook computer
®
that supports USB keyboard and mouse connections, and that runs on
one of these operating systems:
• Windows 2000, XP, 2003, or Vista
® TM
• Mac OS X v10.0 and above
®
• Linux
®
System Requirements 2
Installing your Flip
Before you begin, make sure that your USB keyboard and mouse work
properly with both computers.
1. Power on your computers.
2. Connect your monitor, keyboard, and mouse to the KVM switch.
Now, connect the remote to the KVM switch. Place the remote
anywhere on your desk.
Installing your Flip 3
3. Connect one set of cables to the monitor and USB ports on your
first computer. Wait for your computer to recognize the new USB
device (Flip). Then connect the other set of cables to the monitor
and USB ports on your second computer.
You are now ready to use your Flip.
Flip Tip:
Keep the KVM switch behind your computers
Installing your Flip 4
to keep your desk free of cable clutter.
Using your Flip
When you power on your computers, your first computer's desktop will
appear on your monitor. You are now ready to use that computer as if
it were directly connected to your monitor, keyboard, and mouse.
To switch access to your other computer, simply press the remote.
Your other computer's desktop will appear on your monitor. You are
now ready to use your other computer as if it were directly connected
to your monitor, keyboard, and mouse. Press the remote each time
you want to switch access from one computer to the other.
Note: To download free software for your Flip, please visit our website
at www.belkin.com/flip. You'll also find a list of frequently asked
questions and troubleshooting tips.
Using your Flip 5