Set Up A Multi-Point Bridge - NETGEAR DGN2200v3 User Manual

Set Up a Multi-Point Bridge

Multi-point bridge mode allows a router to bridge to multiple peer access points
simultaneously. Wireless client associations are disabled. Only wired clients can be
connected.
DGN2200 modem router
AP 1
Internet
192.168.0.1
LAN segment 1
Figure 10. Multi-point bridge example
Multi-point bridge mode configuration includes the following steps:
Set up the modem router for wireless repeating as the base station, and specify the MAC
•
addresses of the access points that are repeaters.
Set up the other access points for wireless repeating as repeaters, and specify the MAC
•
address of the modem router as the base station.
Use wireless security to protect this traffic.
•

To set up the multi-point bridge configuration:
In this example, the modem router is AP 1 on LAN Segment 1 because it is in a central
location.
Set up your modem router to be the base station in the bridge.
1.
a. In the Wireless Repeating Function screen for your modem router, select the Enable
Wireless Repeating Function check box.
b. Select the Wireless Base Station radio button.
c. Select the corresponding Disable Wireless Client Association check box.
d. Enter the MAC address for the other access points in the bridge in the Repeater
MAC Address 1 and Repeater MAC Address 2 fields.
N300 Wireless ADSL2+ Modem Router DGN2200v3
PCs
LAN segment 2
Advanced Settings
Point-to-point
bridge mode
Point-to-point
bridge mode
AP 2
Hub or switch
PCs
96
AP 3
Hub or switch
PCs
LAN segment 3