Yamaha ATS-1010 Owner's Manual page 17

Problem
The volume, subwoofer and
audio delay time is not
adjustable.
The unit does not learn the
operation of TV remote
control.
The power state of the unit
and of your TV is opposite.
(For example, though your
TV is on, the unit is in
standby mode.)
The TV remote control is out
of work even if you use TV
remote control relay
function.
You cannot use 3D glasses. The unit obstructs the 3D glasses transmitter of
The picture on your TV
screen becomes blurred or
distorted.
Contact your nearest authorized Yamaha dealer or service center if the following problem occurs.
Problem
The power of the unit
immediately shuts off, and
the INPUT indicator flashes.
Cause
The adjustment has reached the maximum or
minimum.
The remote control sensor of the unit may be
exposed to direct sunlight or lighting.
The screen glare of TV disturbs the remote
control signal.
The batteries of TV remote control may be worn
out.
The button of the unit was not pressed long
enough for the remote control learning
operation.
The TV remote control is not available for
remote control learning.
The TV remote control is outside of the
operation range.
The unit does not enter the remote control
learning mode.
The power state of the unit and of your TV is
opposite from the beginning.
The unit and TV are too close/far from one
another.
Something is between the unit and your TV.
The TV remote control relay function is not
activated.
The TV remote control is not compatible with
the TV remote control relay function.
your TV.
The unit is too close to your CRT TV.
Cause
The protection circuit is activated.
Solution
Reposition the unit.
Disconnect the power cable and perform the
remote control learning operation again.
Replace the batteries.
Press the button of TV remote control in the
order "press 1 second" → "release 1 second" →
"press 1 second"
Use the remote control of the unit.
Point your TV remote control towards the
remote control sensor of the unit keeping a
distance of 30 cm (1 ft) between them.
Operate after checking that the INPUT
indicator is flashing in red.
Press the power button of TV remote control to
set your TV and the unit to standby mode after
pressing the power button of your TV itself and
of the unit to set both your TV and the unit to on.
Try to use the TV remote control relay function
again after repositioning the TV remote control
signal transmitter of the unit and the remote
control sensor of your TV.
Try to use the TV remote control relay function
again after adjusting the height of the unit by
removing or attaching its stands.
Remove the obstruction.
Restart the unit and check the indicator status.
Place the unit (without the stands, for example)
so as not to hide the remote control sensor of
your TV.
Check the position of 3D glasses transmitter of
your TV by referring to the manual of your TV,
and move the unit to the position where there is
no obstruction.
Move the unit away from your TV.
Solution
Troubleshooting
See
page
8
—
—
—
9
9
9
9
9
9
9
—
9
9
—
—
See
page
—
13
En