Table of Contents
Advertisement
P
REPARATION FOR
KICK GUARD
For saws with Kick Guard
cal or asymmetrical low-kick type guide bars.
1. Install bolt (A) in rear hole (B) of Kick Guard
through front hole (C) in guide bar.
2. IMPORTANT: Dimple in Kick Guard
recess in guide bar (E).
3. Tighten nut (F) and bolt (A) until snug. Make certain
Kick Guard
Saw Chain is sharp! Always wear gloves when handling
assembly, otherwise serious personal injury may result.
GUIDE BAR AND SAW CHAIN
• Remove two guide bar nuts and remove sprocket guard (J).
H
• Mount guide bar (G) on studs, and slide toward sprocket to
make saw chain installation easier.
• Install saw chain (H) as shown, with cutters on top of guide
bar facing forward.
G
IMPORTANT
Be certain tensioner (I) fits into lower adjuster hole before
tightening guide bar nuts.
I
NOTE
J
Move chain brake lever fully rearward to install sprocket
guard to saw.
• Install sprocket guard (J), and tighten guide bar nuts finger
tight.
• Adjust saw chain tension, as instructed in "Adjustment,
Chain Tension."
7
U
SE
®
TO BAR INSTRUCTIONS
®
P/N 2894901 and symmetri-
®
is flush against guide bar.
WARNING
®
and
®
(D) must engage
DANGER
Hide quick links:
Advertisement
Table of Contents
