Setting the Bass Control
You can change the Bass Frequency emphasis to create your own tonal
preference.
1
Press MENU to select the BASS ENGINE mode, then
press MODE.
BBE
BASS ENGINE
SETUP
RETURN (OFF)
BBE
2
Press
or
to select the BASS (Bass Center
Frequency) control mode.
BASS
TREBLE
Setting the Bass Center Frequency
3
-1 Press SOURCE/POWER to select the desired bass
center frequency.
80Hz
100Hz
120Hz
60Hz
80Hz
Emphasize the displayed bass frequency ranges.
Setting the Bass Bandwidth
3
-2 Press BAND to select the desired bass bandwidth.
Change the boosted bass bandwidth to wide or narrow. A
wide setting will boost a wide range of frequencies above
and below the center frequency. A narrower setting will
boost only frequencies near the center frequency.
Setting the Bass Level
3
*
Turn the Rotary encoder to select the desired bass
-3
level (–7~+10).
You can emphasize or weaken the bass level.
4
Press MENU to select RETURN.
After 2 seconds, the unit returns to normal mode.
Pressing and holding MENU for at least 2 seconds will
return to normal mode.
• If no operation is performed within 60 seconds, the bass control
setting will be turned off automatically.
• The bass level settings will be individually memorized for each
source (FM, AM, CD, etc.) until the setting is changed. The bass
frequency and bass bandwidth settings adjusted for one source are
effective for all other sources (FM, AM, CD, etc.).
• Depending on the connected devices, some functions and display
indications do not work. However, Bass Level is still adjustable if an
audio processor with the Bass function is connected.
• This function is inoperable when DEFEAT is set to ON.
• While in the bass adjusting mode, TREBLE CONTROL adjusting
mode can be recalled by pressing
or
.
* The adjustment can also be made by pressing MODE. Refer to
"Adjusting Bass/Treble/Balance (Between Left and Right)/Fader
(Between Front and Rear)/Defeat" (page 13).
Page 13