HighPoint ATA-133 RAID User Manual page 22

Raid controller
Table of Contents

Advertisement

BIOS Configuration Utility
1. Power off and replace the failed drive
This command enables user to power off the computer and replace the failed
disk with a good one. If your computer does not support APM, you must turn
off your computer manually. After replacement, user can boot into BIOS and
select the
3. Choose replacement drive and rebuild
array.
2. Destroy the mirroring relationship
This command enables user to cancel the broken array's data mirroring
relationship. For broken RAID 1 array, the data on the remained normal disk
will be reserved after the destroy operation. For broken RAID 0+1 array, all
data on the array will be lost after destroy operation!
3. Choose replacement drive and rebuild
This command enables user to select an already-connected disk to rebuild the
broken array and replace the data to that disk.
1. After chosen this command line, the
below:
to rebuild the broken
Status
column will be activated, see
2-8

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hpt370Hpt372

Table of Contents