Menu Operations; Preparation For Menu Operation; Adjusting The Gray Balance - Sony UP-DR200 Operating Instructions Manual

Digital photo printer
Hide thumbs Also See for UP-DR200:
Table of Contents

Advertisement

Notes
• About 20 printout sheets can be stored in the output
tray in most cases. However, this number can vary
greatly depending on the amount of curling in
printouts. In general, you should remove ejected
printouts as soon as possible.
Additionally, you must adjust the position of the
output stopper according to the printing pack you will
use.
For details, see “Attaching the Output Tray” on page
13.
• Do not touch a printout until it is completely ejected
from the printer. If you touch the printout while it is
being ejected, it may not be printed properly.
To stop printing midway
Press and hold the PRINT STOP button for more than
one second. The page currently being printed is
completed and ejected. After the printout is ejected, the
information display returns to READY. The image data
stored in the memory and the number of printings set in
the queue are cancelled.
Memory capacity
Image data transferred from the computer is stored in the
memory of the printer. Data for one more image can be
stored in addition to that of the one being printed.
If the printer does not print
When an error message is displayed on the LCD, you
cannot operate the printer. Take remedies according to
the advice given in “List of Messages” on page 28.
Notes on storing your printouts
• Avoid exposure to direct sunlight, or conditions of
high temperature and high humidity, which could
cause the colors to fade.
• Avoid applying tape to a printout, and avoid contact
with plastic objects such as erasers and desk mats.
• Do not allow alcohol or other volatile organic solvents
to come into contact with the printouts.

Menu Operations

You can adjust or confirm the following items using the
menu.
• Adjustment of the gray balance
• Display of the total quantity of pages printed
• Display of the firmware version of the printer

Preparation for Menu Operation

Use the MENU button to perform menu operations. The
MENU button is located under the operation button
door.
1
Press the top right of the operation button door.
The door opens, revealing the operation buttons.
2
Carry out the operation using these buttons
including the MENU button.

Adjusting the Gray Balance

Use the ink ribbon with the paper that is supplied as a set
in the same package. The gray balance of the printer is
set to No. 0, which is designated as the achromatic color,
as the factory setting. If you want to change the gray
balance, proceed as follows. This setting is retained even
when the printer is turned off.
There may be differences among packages where the ink
ribbon and paper rolls are contained as a set due to
handling during transportation and storage.
Page 19
Menu Operations

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents