If The Ink Ribbon Breaks During Use - Sony UP-DR200 Operating Instructions Manual

To remove the output tray
Hold the output tray on both sides, and 1 raise the tray
while 2 pulling it toward you.
2
1

If the Ink Ribbon Breaks during Use

The remaining ribbon can be used after repairing it with
adhesive tape.
1
Open the ribbon door, and remove the ribbon tray.
2
Pull the ribbon on the white spool, attach one edge
of a strip of adhesive tape along the entire length of
the ribbon's end, and then attach the other edge of
the tape to the ribbon on the black spool.
2 Attach the adhesive tape along
the entire length of the white
1 Wind the
spool to feed spool's ribbon end, and attach it to
the ribbon on the black spool.
the ribbon out.
3
Remove any slack from the ribbon.
Wind the black spool to remove any slack.
Note
Be sure to wind the taped portion completely onto
the black spool so that the tape is not exposed.
4
Hold the center of the ribbon tray, and load it into
the printer.
Note
Always hold the center of the ribbon tray when
loading it into the printer. If you hold the tray by
any other part, your fingers may get caught while
inserting the tray and injuries may result.
5
Close the ribbon door.
Depending on the position of the ribbon break, a
single printout's worth of ribbon may be lost.
Loading the Paper Roll and Ink Ribbon
15