Attaching The Scrap Receptacle; Attaching The Output Tray - Sony UP-DR200 Operating Instructions Manual

5
Hold the center of the ribbon tray, and load it into
the printer.
Notes
• Always hold the center of the ribbon tray when
loading it into the printer. If you hold the tray by
any other part, your fingers may get caught while
inserting the tray and injuries may result.
• Be sure to insert the ribbon tray fully into the
printer.
6
Close the ribbon door.
Notes on storage
• Avoid placing the printer where it will be subject to:
– high temperatures,
– high humidity or dust,
– direct sunlight.
• After opening the bag, use the ribbon and the paper as
soon as possible.
• When transporting or storing the paper roll and ink
ribbon after partial use, we recommend putting them
back into their respective bags.

Attaching the Scrap Receptacle

When printing, a margin of empty space is left between
each printout. These excess portions are cut off and
dropped into the scrap receptacle. Remove scraps from
the receptacle as soon as possible.
Note
If the scrap receptacle becomes too full, scraps that are
cut off may be unable to eject. This may result in
malfunction. Remove scraps from the receptacle as soon
as possible, and be sure to empty the receptacle
whenever you replace a paper roll.

Attaching the Output Tray

When printing, printouts are ejected from the printer and
collect in the output tray.
1
Attach the output tray to the printer.
Loading the Paper Roll and Ink Ribbon
13