Engine Pcb - Brother HL-1440 Service Manual

1.4

Engine PCB

The gate array which transforms the serial signal from the main PCB into the parallel signal is
mounted on the engine PCB.
The engine PCB controls the following parts by using the transferred signal data;
Main motor
•
Panel PCB
•
Fan motor
•
Thermistor
•
Polygon motor
•
Solenoid
•
High-voltage power supply
•
For the circuit diagram of the engine PCB, see
1.5 BR-net PCB (for HL-1470N only)
The BR-net PCB is connected to the ASIC mounted on the main PCB through the PCI bus.
The Ethernet controller, AM79C973AKC is mounted on the BR-net PCB. The controller
incorporates the 10/100 Mbps physical interface which conforms to IEEE 802.3 and is
connected with the external Ethernet through the RJ-45 connector.
For the circuit diagram of the BR-net PCB, see
Toner sensor
•
Cover sensor
•
Front registration sensor
•
Rear registration sensor
•
Upper paper cassette sensor (HL-1450/1470N only)
•
Lower paper cassette registration sensor (HL-1450/1470N only)
•
Jam sensor
•
Appendix
Appendix
3-19
CHAPTER 3 THEORY OF OPERATION
18.
19.