Lexmark Dot Matrix Manual page 71

Media specifications
Labels Width:
Length:
Weight:
Thickness:
Smoothness:
* 150 - 250 Sheffield is optimal. Using media higher than 300 Sheffield could result in printing degradation.
Card stock Weight:
Note: Always use the rear exit when printing on card stock. To minimize curl, use the rear exit when printing on labels.
Card stock and label guidelines
When printing on labels:
• Set the Paper Type to Labels from the printer driver, the Local Printer Setup Utility, or MarkVision.
•
Do not load labels together with paper or transparencies in the same paper source.
•
Do not use label sheets with a slick backing material.
•
Do not print within 1 mm (0.040 in.) of the die-cut.
• Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a paper jam. Partial
sheets will also contaminate your printer and your cartridge with adhesive, and could void your printer and cartridge
warranties.
• Use labels that can withstand temperatures of 205°C (401°F) without sealing, excessive curling, wrinkling, or
releasing hazardous emissions.
•
Use labels that can withstand pressure of 25 pounds per square inch (psi).
•
Do not print within 1 mm (0.040 in.) of the edge of the label, of the perforations, or between die-cuts of the label.
• Do not use label sheets that have adhesive to the edge of the sheet. We recommend zone coating of the adhesive
at least 1 mm (0.040 in.) away from edges. Adhesive material will contaminate your printer and could void your
warranty.
• If zone coating of the adhesive is not possible, a non-oozing adhesive should be used. Unlike other printers, do
not remove the leading or driver edge.
•
The perforation locations may impact printer reliability.
Note: Test any perforated card stock or paper before purchasing large quantities.
•
Portrait orientation is preferred, especially when printing bar codes.
•
Do not use labels that have exposed adhesive.
•
For the multipurpose feeder, load labels with the recommended print side faceup and the top edge going in first.
For the tray, load labels with the recommended print side facedown.
When printing on card stock:
•
Set the Paper Type to Card Stock from the printer driver, the Local Printer Setup Utility, or MarkVision.
• Do not use preprinted card stock manufactured with chemicals that may contaminate the printer. Preprinting
introduces semi-liquid and volatile components into the printer.
•
Do not use card stock that is creased. It may cause paper jams.
76.2–216 mm (3.0–8.5 in.)
127–355.6 mm (5–14 in.)
2
Up to 199 g/m (53 lb)
Up to 0.25 mm (0.01 in.)
100–400* Sheffield
2
Up to 163 g/m Index Bristol (90 lb)
2
Up to 163 g/m Tag (100 lb)
Printer specifications
71