Overview of touch probe cycles
U
The soft-key row shows the available groups of
cycles.
Cycle group
Cycles for automatic measurement and compensation of workpiece misalignment
Cycles for automatic workpiece presetting
Cycles for automatic workpiece inspection
Calibration cycles, special cycles
Cycles for automatic kinematics measurement
Cycles for automatic tool measurement (enabled by the machine tool builder)
U
If required, switch to machine-specific touch probe
cycles. These touch probe cycles can be integrated
by your machine tool builder.
46
Soft key
Page
Page 320
Page 342
Page 396
Page 446
Page 462
Page 494
Fundamentals / Overviews