HEIDENHAIN ITNC 530 - CYCLE PROGRAMMING User Manual page 320

14.1 Fundamentals
Overview
The TNC provides five cycles that enable you to measure and
compensate workpiece misalignment. In addition, you can reset a
basic rotation with Cycle 404:
Cycle
400 BASIC ROTATION Automatic
measurement using two points.
Compensation via basic rotation.
401 ROT OF 2 HOLES Automatic
measurement using two holes.
Compensation via basic rotation.
402 ROT OF 2 STUDS Automatic
measurement using two studs.
Compensation via basic rotation.
403 ROT IN ROTARY AXIS Automatic
measurement using two points.
Compensation by turning the table.
405 ROT IN C AXIS Automatic
alignment of an angular offset between
a hole center and the positive Y axis.
Compensation via table rotation.
404 SET BASIC ROTATION Setting any
basic rotation.
320
Soft key Page
Page 322
Page 325
Page 328
Page 331
Page 336
Page 335
Touch Probe Cycles: Automatic Measurement of Workpiece Misalignment