Yaesu FT-950 Operating Manual page 129

Receiver
Circuit Type:
Intermediate Frequencies:
Sensitivity:
Squelch Sensitivity:
(RF AMP 2 "ON")
Selectivity (WIDTH: Center):
Image Rejection:
Maximum Audio Output:
Audio Output Impedance:
Conducted Radiation:
Specifications are subject to change, in the interest of technical improvement, without notice or obligation, and are
guaranteed only within the amateur bands.
FT-950 O
PERATING
Triple-conversion Superheterodyne
69.450 MHz/450 kHz/30 kHz (24 kHz for AM/FM)
SSB (BW: 2.4 kHz, 10 dB S+N/N)
4 μV (0.5 - 1.8 MHz) (IPO "ON")
0.2 μV (1.8 - 30 MHz) (RF AMP 2 "ON")
0.125 μV (50 - 54 MHz) (RF AMP 2 "ON")
AM (BW: 6 kHz, 10 dB S+N/N, 30 % modulation @400 Hz)
28 μV (0.5 - 1.8 MHz) (IPO "ON")
2 μV (1.8 - 30 MHz) (RF AMP 2 "ON")
1 μV (50 - 54 MHz) (RF AMP 2 "ON")
FM (BW: 15 kHz, 12 dB SINAD)
0.5 μV (28 - 30 MHz) (RF AMP 2 "ON")
0.35 μV (50 - 54 MHz) (RF AMP 2 "ON")
There is no specification for frequency ranges not listed.
SSB/CW/AM
2 μV (0.1 - 1.8 MHz)
2 μV (50 - 54 MHz)
FM
1 μV (28 - 30 MHz)
1 μV (50 - 54 MHz)
There is no specification for frequency ranges not listed.
Mode
CW/RTTY/PKT
SSB
AM
FM
70 dB or better (160 - 10m Amateur bands)
60 dB or better (6m Amateur band)
2.5 W into 4 Ohms with 10% THD
4 to 8 Ohms (4 Ohms: nominal)
Less than 4 nW
M
ANUAL
S
PECIFICATIONS
–6 dB –60 dB
0.5 kHz or better 750 Hz or less
2.4 kHz or better 3.6 kHz or less
6 kHz or better 15 kHz or less
15 kHz or better 25 kHz or less
Page 127