Yaesu FT-847 Operating Manual page 92

Hf + v-uhf all mode transceiver
Hide thumbs Also See for FT-847:
Table of Contents

Advertisement

Menu System
92 [USB-CAR]
Function:
Available Values: 10 ~ 15 (x 10) Hz
Default Setting: 0 Hz
Analogous to "IF Shift" on receive, the TX Carrier
Point adjustment allows you to shift the IF passband
so as to roll off excessive bass or treble frequencies,
depending on your voice pattern, microphone fre-
quency response, etc. The TX Carrier Point may be
adjusted in steps of 10 Hz.
93 [LSB-CAR]
Function:
Available Values: 10 ~ 15 (x 10) Hz
Default Setting: 0 Hz
Analogous to "IF Shift" on receive, the TX Carrier
Point adjustment allows you to shift the IF passband
so as to roll off excessive bass or treble frequencies,
depending on your voice pattern, microphone fre-
quency response, etc. The TX Carrier Point may be
adjusted in steps of 10 Hz.
90
M
ENU
Adjust T
USB carrier injection
X
point.
(i.e. 100 ~ 150 Hz)
Adjust T
LSB carrier injection
X
point.
(i.e. 100 ~ 150 Hz)
S
D
ELECTION
ETAILS
94 [CLN RATE]
Function:
Available Values: 9600/57600 bps
Default Setting: 9600 bps
Both radios used in the cloning process must be set to
the same baud rate.
95 [SEND CLN]
Function:
When this Menu selection is active, pressing the
[MCK/W] key causes cloning data to be sent to an-
other FT-847.
96 [RCV CLN]
Function:
When this Menu selection is active, pressing the
[MCK/W] key places the FT-847 in the "Clone Data
Receive" mode, ready to accept the transfer of clon-
ing data from another FT-847.
Set the data transfer rate to be used
during cloning.
Transmit cloning data to another
FT-847.
Receive cloning data from another
FT-847.
FT-847 O
PERATING
M
ANUAL

Advertisement

Table of Contents
loading

Table of Contents