Heat And Ventilation; Base Station Wire Stand - Yaesu FT-847 Operating Manual

Hf + v-uhf all mode transceiver
Hide thumbs Also See for FT-847:
Table of Contents

Advertisement

H
EAT AND
To ensure long life of the components, be certain to
provide adequate ventilation around the cabinet of the
FT-847. The cooling system of the transceiver must
be free to draw cool air in from the side of the trans-
ceiver and expel warm air from the rear of the trans-
ceiver.
Do not install the transceiver on top of another heat-
generating device (such as a linear amplifier), and do
not place equipment, books, or papers on top of the
transceiver. Place the transceiver on a hard, flat, stable
surface. Avoid heating vents and window locations that
could expose the transceiver to excessive direct sun-
light, especially in hot climates.
FT-847 O
PERATING
V
ENTILATION
M
ANUAL
Installation
B
S
ASE
TATION
The heavy wire stand on the bottom of the transceiver
allows the transceiver to be tilted upward for better
viewing. Simply fold the stand forward to raise the
front of the transceiver, and fold it back against the
bottom case to lower the front of the FT-847.
Note: Do not use the wire stand as a carrying handle,
as it could slip out of its mount, causing the trans-
ceiver to be dropped! Use the carrying handle on the
side of the FT-847 for transport purposes.
W
S
IRE
TAND
13

Advertisement

Table of Contents
loading

Table of Contents