Transmitting In The Beacon Mode - Yaesu FT-2000D Operating Manual

C CW M
HECKING THE EMORY
1. Be sure that Break-in is still turned Off by the [ BK-IN ]
button.
2. Press the [ MONI ] button to enable the CW monitor.
3. Press the [ F1 ( CH1 )] ~ [ F4 ( CH-4 )] button to check
your work. You will hear the results in the sidetone,
but no RF energy will be transmitted.
N :
OTE
Adjust the monitor level using the [ MONI ] knob.
O -T -A CW M
N HE IR ESSAGE
1. Press the [ BK-IN ] button to enable transmission. Ei-
ther Full- or Semi-break-in will be engaged, depend-
ing on the setting of Menu item "060 A1A BK-IN."
2. Press the [ F1 ( CH1 )] ~ [ F4 ( CH-4 )] button to transmit
the programmed message.
N :
OTE
If you subsequently decide to use the "Text Memory" tech-
nique for memory storage, please note that the contents of
a message stored using keyer paddle input will not be trans-
ferred over when you select "Text Memory technique" on
a particular memory register (the Menu Mode Setting is
set to "tyP1
tyP1 tyP1"). tyP1
tyP1
It is possible to transmit, repetitively in a "Beacon" mode, any message programmed either via paddle input or via
the "Text" input method. The time delay between message repeats may be set anywhere between 1 ~ 255 seconds
via Menu item "018 tEy BEACON." If you do not wish the message to repeat in a "Beacon" mode, please set this
Menu item to "OFF." Press the [ F1 ( CH1 )] ~ [ F4 ( CH-4 )] button, depending on the register into which the Beacon
message is stored. Repetitive transmission of the Beacon message will begin. Press one of these keys once more to
halt the Beacon transmissions.
FT-2000D O
PERATING
CW C
C M
ONTEST
C
ONTENTS
P
LAYBACK

Transmitting in the Beacon Mode

M
ANUAL
ONVENIENCE
K
EMORY EYER
[ BK-IN ] Button
[ F1 ( CH-1 )] ~ [ F4 ( CH-4 )] Button
[ BK-IN ] Button
[ F1 ( CH-1 )] ~ [ F4 ( CH-4 )] Button
F
EATURES
Page 89