Cooling Fan - Yaesu FT-2000 Operating Manual

RX ANT OUT Jack
This BNC jack provides output of the receiver signal
lines from the Antenna jacks which are connected to
"RX" side of the transceiver's main T/R switching cir-
cuitry.
RX ANT IN Jack
This type-M jack is for a separate receive-only antenna.
An antenna connected here can be used when the [ RX ]
antenna button on the front panel is pressed.
If you want to use some special kind of external
bandpass filter or preamplifier, you may connect it
between the RX ANT OUT and RX ANT IN jacks.
ANT 1/2 Jacks
Connect your main antenna(s) here, using a type-M
(PL-259) plug and coaxial feedline for each. These an-
tenna ports are always used for transmission, and also
are used for reception unless a separate receive an-
tenna is also used for the receiver. The internal antenna
tuner affects only the antenna(s) connected here, and
only during transmission.
ANTENNA ( 1/2 ) SWITCH
TX/RX RELAY
ANT "1"
ANT "2"
RX ANT "OUT"
RX ANT "IN"
FT-2000D O
Transmitter Section
ANTENNA ( RX ) SWITCH
Receiver Section
M
R
EAR

COOLING FAN

This is a cooling fan for cooling down the Power Am-
plifier Unit.
Usually, this cooling fan does not rotate. However,
when the temperature begins to rise, the cooling fan
begins to rotate.
DC 13.8 V ... IN Jack
Connect this 6-pin connector to the DC 13.8 V Output
Jack on the FP-2000 AC Power Supply, using the sup-
plied DC Power Cord. This connector provides +13.8
V DC supply voltage for the FT-2000D.
DC 50 V ... IN Jack
Connect this 2-pin connector to the DC 50 V Output
Jack on the FP-2000 AC Power Supply, using the sup-
plied DC Power Cord. This connector provides +50 V
DC supply voltage for the power amplifier of the FT-
2000D.
GND
Use this terminal to connect the transceiver to a good
earth ground, for safety and optimum performance. Use
a large diameter, short braided cable for making ground
connections, and please refer to page 9 for other notes
about proper grounding.
µ-TUNE Jacks
These jacks are used for signal input/output of the op-
tional RF µTuning Kit.
P
ANEL
Page 31