Tuner Mode - DigiTech RP100 User Manual

Modeling guitar processor
Table of Contents

Advertisement

Tuner Mode

The Tuner in the RP100 allows you to quickly tune or check the tuning on your guitar. Enter
Tuner mode by pressing and holding both Footswitches simultaneously.The Display will briefly
show tu indicating that you are in Tuner mode. To begin tuning, play a note on your guitar (a
harmonic at the 12th fret usually works best).The Display shows the note being played.The
Matrix LEDs indicate whether you are sharp or flat.The top 4 Red LEDs indicate the note is
sharp and should be tuned down.The bottom 4 Red LEDs indicate the note is flat and should be
tuned up.The center Green LED indicates the note is in tune. The output is muted in Tuner
mode.
In Tuner mode, you can change your tuning reference.The default factory setting is A=440 Hz.
(displayed as 40). Rotating the Parameter 1 knob will select alternate dropped tunings.
Alternate tunings are A = Ab (displayed as Ab), A = G (displayed as g), and A = Gb (displayed as
gb).The display window will briefly flash the currently selected tuning preference.
Exit tuner mode by pressing both Footswitches simultaneously.
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents